00 11 500 Checking/topping up oil level in automatic transmission (GA8P70H) N55_Hybrid
WARNING: This page does not describe the selected car, but rather 50 other vehicles, including the 2016 BMW M5, 2016 BMW ActiveHybrid 5, 2016 BMW 550i xDrive, 2016 BMW 550i, and 2016 BMW 535i xDrive. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
High-voltage system - danger to life:
High-voltage system is active and is live (1000 volt AC)!
High-voltage system is active and is live (1000 volt AC)!
NOTE:
Observe SAFETY INFORMATION
for handling hybrid cars.
IMPORTANT:
- Do not let skin come in contact with transmission oil and do not inhale transmission oil vapors.
- Wear protective gloves.
- Ensure adequate ventilation
IMPORTANT:
Use only the approved TRANSMISSION OIL
.
To set the correct level, it is mandatory that the service function "Transmission control unit: oil adjustment" is performed using the diagnosis system.
Failure to comply with this requirement will result in serious damage to the automatic transmission .
Conditions for oil level adjustment with BMW diagnosis system:
To set the correct level, it is mandatory that the service function "Transmission control unit: oil adjustment" is performed using the diagnosis system.
Failure to comply with this requirement will result in serious damage to the automatic transmission .
Conditions for oil level adjustment with BMW diagnosis system:
- Initial condition: Transmission oil temperature 30° to 40°C
- Final condition: Transmission oil temperature 40° to 50°C
Performing oil-level adjustment:
An oil-level adjustment is necessary for certain fault code entries in the automatic transmission and after repair (e. g. mechatronic replacement, converter replacement, transmission replacement).
- Connect diagnosis and information system
- Open service function (powertrain)
- Carry out oil level check in accordance with instructions
Adding transmission oil:
Stand vehicle on a level surface and secure against rolling off.
Undo oil filler plug (1).
Add automatic transmission fluid according to instructions in the BMW diagnosis system.
Installation note:
Replace sealing ring/oil filler plug
Tightening torque: 24 11 3AZ .
Tighten down oil filler plug using
- Hexagon socket wrench AF 8
- Torque wrench
- Socket AF 8