13 54 030 Removing and installing/sealing throttle body (N55 Hybrid)

WARNING: This page does not describe the selected car, but rather 50 other vehicles, including the 2016 BMW M5, 2016 BMW ActiveHybrid 5, 2016 BMW 550i xDrive, 2016 BMW 550i, and 2016 BMW 535i xDrive. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: High-voltage system - danger to life!

The following points must be strictly observed prior to starting work :

Observe SAFETY INFORMATION for handling hybrid cars

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION) .

Necessary preliminary tasks:

Switch off ignition.
Remove rear CHARGE-AIR DUCT .

Unlock connector (1) and remove.

Unlock hose (2) and detach.

Remove tank vent valve (3) from holder in the direction of arrow and place aside.

Fig 1: Identifying Tank Vent Valve, Hose And Connector

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock connector (1) and remove.

Release screws (3).

Partially remove throttle body (4) and unlock tank ventilation line (2) and remove.

Tightening torque 13 54 1AZ .

Remove throttle body (4).

Fig 2: Identifying Throttle Body, Connector And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Replace sealing ring (1) of throttle body (2).

Fig 3: Identifying Throttle Body Sealing Ring

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Check stored fault message.

Delete fault memory.