13 54 030 Removing and installing/sealing throttle body (N20)

WARNING: This page does not describe the selected car, but rather 50 other vehicles, including the 2016 BMW M5, 2016 BMW ActiveHybrid 5, 2016 BMW 550i xDrive, 2016 BMW 550i, and 2016 BMW 535i xDrive. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION) .

Necessary preliminary tasks:

Switch off ignition.
Release CHARGE AIR DUCT on throttle body and lay it on its side.

Unlock tank ventilation line (1) and disconnect.

Unlock connector (2) and remove.

Release screws (3).

Tightening torque 13 54 1AZ .

Remove throttle body (4).

Fig 1: Identifying Tank Ventilation Line, Throttle Body, Connector And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Replace sealing ring (1) of throttle body (2).

Fig 2: Identifying Throttle Body Sealing Ring

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Check stored fault message.

Delete fault memory.