13 62 560 Removing and installing/replacing the hot film air mass meter (N55 Hybrid)

WARNING: This page does not describe the selected car, but rather 50 other vehicles, including the 2016 BMW M5, 2016 BMW ActiveHybrid 5, 2016 BMW 550i xDrive, 2016 BMW 550i, and 2016 BMW 535i xDrive. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: High-voltage system - danger to life!

The following points must be strictly observed prior to starting work :

Observe SAFETY INFORMATION for handling hybrid cars

Necessary preliminary tasks:

Read out the fault memory of the DME control unit.
Switch off ignition.
Remove IGNITION COIL COVER .

Release clamps (1).

Tightening torque 13 71 3AZ .

Unlock connector (2) on hot film air mass meter and disconnect.

Disconnect clean air pipe (3) from rubber mount at top and remove.

Fig 1: Identifying Air Pipe, Connector And Clamps

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Tightening torque 13 71 4AZ .

Pull hot-film air mass meter (2) out of upper section of clean air pipe.

Fig 2: Identifying Hot-Film Air Mass Meter And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Check stored fault message.

Delete fault memory.