11 31 Camshaft
WARNING: This page does not describe the selected car, but rather 50 other vehicles, including the 2016 BMW M5, 2016 BMW ActiveHybrid 5, 2016 BMW 550i xDrive, 2016 BMW 550i, and 2016 BMW 535i xDrive. However, it is still accessible from the selected car via links, so may be relevant.
TIGHTENING TORQUE SPECIFICATIONS - CAMSHAFT
| Type | Thread | Tightening specification | Measure | ||
|---|---|---|---|---|---|
| 1AZ | ASA screws Chain drive module, slide rail to cylinder head bearing cap. |
N52T | M6 x 35 | 8 Nm | |
| 2AZ | Bearing pin Guide rail with tensioning rail to crankcase |
N52T | M8 | 20 Nm | |
| 3AZ | Guide pin Guide rail to cylinder head |
N52T | M7 | 14 Nm | |
| 4AZ | Chain tensioner Chain tensioner to cylinder head. |
N52T | M22 x 1.5 | Replace sealing ring. Lightly grease or oil thread. |
55 Nm |
| 5AZ | Plug Assembly opening to cylinder head. |
N52T | M18 x 1.5 | 25 Nm | |
| 6AZ | ASA screws Bearing strip to cylinder head (exhaust camshaft). |
N52T | M7 x 70 | Jointing torque | 8 Nm |
| Torque angle | 60 ° | ||||
| 9AZ | ASA screws Camshaft bearing cap to cylinder head. |
N52T | M6 x 30.5 | 9 Nm | |