34 52 535 Replacing A Rear Pulse Sensor

WARNING: This page does not describe the selected car, but rather 50 other vehicles, including the 2016 BMW M5, 2016 BMW ActiveHybrid 5, 2016 BMW 550i xDrive, 2016 BMW 550i, and 2016 BMW 535i xDrive. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD protection).

Necessary preliminary tasks:

Remove rear WHEEL .
Read and comply with GENERAL INFORMATION .

Open housing cover.

Disconnect plug connection (1).

Installation note:

Ensure proper locking of plug connection and proper seating of rubber grommets.

Fig 1: Rear Pulse Sensor Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.

Disengage line (1) along marked lines from holders.

Installation note:

Ensure proper locking of the holders and proper seating of the line in the brackets.

Fig 2: Unclip Line

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1).

Withdraw wheel speed sensor (2) from bore hole.

Installation note:

Tightening torque: 34 51 3AZ .

Clean bore for pulse sensor and lubricate with Staburags NBU 12/K lubricating grease.

Fig 3: Wheel Speed Sensor And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Prior to installation, check sensor head for damage and replace if necessary.