34 33 200 Removing And Installing/Replacing Electric Vacuum Pump

WARNING: This page does not describe the selected car, but rather 50 other vehicles, including the 2016 BMW M5, 2016 BMW ActiveHybrid 5, 2016 BMW 550i xDrive, 2016 BMW 550i, and 2016 BMW 535i xDrive. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: High-voltage system - danger to life!
The following points must be strictly observed prior to starting work :

Observe SAFETY INFORMATION for handling electric cars.

Necessary preliminary work:

Remove FRONT ASSEMBLY UNDERSIDE PROTECTION .
Remove STEERING AGGREGATES COVER LEFT AND RIGHT .

Release screws (1) from anti-roll bar.

Installation note:

Replace screws.

Tightening torque: 31 35 1AZ .

Fig 1: Screws From Anti-Roll Bar

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1) from auxiliary water pump holder.

Tightening torque: 11 51 5AZ .

Secure auxiliary water pump (2) in sideways direction.

Installation note:

Make sure holders of auxiliary water pump (2) to retaining bracket are correctly seated.

Fig 2: Screws From Auxiliary Water Pump Holder

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock plug connection (1) and disconnect.

Unlock and detach vacuum line (2).

Detach vent hose (3).

Installation note:

To facilitate installation, coat vent hose (3) with lubricant.

Fig 3: Plug Connection, Vacuum Line And Vent Hose

Courtesy of BMW OF NORTH AMERICA, INC.

Turn connector (1) in direction of arrow and pull off from holder for electric vacuum pump.

Release screw (2).

Tightening torque: 34 33 3AZ .

Feed electric vacuum pump out forwards.

Fig 4: Pulling Holder For Electric Vacuum Pump

Courtesy of BMW OF NORTH AMERICA, INC.