32 31 102 Replacing Bottom Steering Shaft (All-Wheel Drive Vehicle)
WARNING: This page does not describe the selected car, but rather 47 other vehicles, including the 2016 BMW M5, 2016 BMW ActiveHybrid 5, 2016 BMW 550i xDrive, 2016 BMW 550i, and 2016 BMW 535i xDrive. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary work:
- Remove cover of pedal mechanism. See 51 45 184 REMOVING AND INSTALLING (REPLACING) TRIM PANEL FOR PEDAL MECHANISM (ECE ONLY) or 51 45 184 REMOVING AND INSTALLING (REPLACING) TRIM PANEL FOR PEDAL MECHANISM (US ONLY) .
- Remove underbody protection at front and rear. See 51 47 490 REMOVING AND INSTALLING/REPLACING UNDERBODY PROTECTION (FRONT) or 51 47 491 REMOVING AND INSTALLING/REPLACING REAR UNDERBODY PROTECTION .
- Remove STIFFENING PLATE .
- Remove EXHAUST SYSTEM (N63 only).
- Remove CATALYTIC CONVERTER (only N63).
- Remove heat shield (N63 only).
- Release SCREW CONNECTION FOR UNIVERSAL JOINT WITH CORRUGATED TUBING on bottom steering shaft and pull off universal joint.
Release screws (1) from cover (2) on bulkhead.
Pull cover towards front until steering shaft collar is visible.
Pull out both expanding pins (see arrows) from steering shaft collar.
IMPORTANT:
Before removal: Mark connection of steering shaft/steering column in relation to each other with mark (1)!
Non-compliance results in steering wheel inclination!
Non-compliance results in steering wheel inclination!
Release screw (2) and pull off steering shaft!
Installation note:
Replace screw.
Clean screw threads to remove all remnants of screw locking adhesive.
Screw must lie in groove of steering column shaft.
No subsequent retorquing permitted!
Tightening torque: 32 31 3AZ .
Press in latch mechanisms (see arrows) from footwell and press out complete steering shaft collar (1) with steering shaft from bulkhead.
Remove steering shaft towards bottom from engine compartment complete with cover for bulkhead and steering shaft collar!