32 41 280 Removing And Installing/Replacing Oil Reservoir (N63T)

WARNING: This page does not describe the selected car, but rather 47 other vehicles, including the 2016 BMW M5, 2016 BMW ActiveHybrid 5, 2016 BMW 550i xDrive, 2016 BMW 550i, and 2016 BMW 535i xDrive. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: DANGER OF POISONING if oil is ingested/absorbed through the skin!
RISK OF INJURY if oil comes into contact with eyes and skin!

IMPORTANT: Adhere to the utmost cleanliness. Do not allow any dirt to enter the hydraulic system.
Seal off hydraulic lines with seal plugs.

Necessary preliminary work:

Draw off and dispose of hydraulic fluid from oil reservoir.
Remove front left SUSPENSION CROSS-BRACE .
Remove LEFT INTAKE PORT .
Remove ENGINE CONTROL UNIT from oil reservoir and place to one side.

Release screws (1) on oil reservoir and press oil reservoir (2) forwards until the return and suction line hose clamps can be reached.

See the following Fig 1.

Fig 1: Screws On Oil Reservoir

Courtesy of BMW OF NORTH AMERICA, INC.

Release hose clamps (1) and (3) and detach suction and return lines.

Tightening torque: 32 41 3AZ .

Unfasten plug connection (2) from oil level sensor and disconnect.

Release screw (4), remove holder from reservoir and remove reservoir.

Installation note:

Renew hose clamps.

Fig 2: Hose Clamps, Plug Connection And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

If applicable, transfer oil level sensor.

After installation:

If necessary, carry out INITIAL DYNAMIC DRIVE OPERATION .
Check line connections for leaks.