32 41 060 Removing And Installing Vane Pump For Hydraulic Steering (N57)
WARNING: This page does not describe the selected car, but rather 47 other vehicles, including the 2016 BMW M5, 2016 BMW ActiveHybrid 5, 2016 BMW 550i xDrive, 2016 BMW 550i, and 2016 BMW 535i xDrive. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
DANGER OF POISONING
if oil is ingested/absorbed through the skin!
RISK OF INJURY if oil comes into contact with eyes and skin!
RISK OF INJURY if oil comes into contact with eyes and skin!
IMPORTANT:
Adhere to the utmost cleanliness. Do not allow any dirt to enter the hydraulic system.
Seal off hydraulic lines with seal plugs.
Seal off hydraulic lines with seal plugs.
Necessary preliminary tasks:
- Draw off and dispose of hydraulic fluid from oil reservoir.
- Remove front UNDERBODY PROTECTION .
- Remove front stiffening plate (F12 all-wheel drive vehicle).
- Remove left intake port.
- Remove FAN COWL WITH ELECTRIC FAN .
- Remove belt pulley . See 32 41 100 REMOVING AND INSTALLING/REPLACING BELT PULLEY ON VANE PUMP FOR POWER STEERING or 32 41 105 REMOVING AND INSTALLING/REPLACING BELT PULLEY FOR HYDRAULIC PUMP .
Release hose clamp (1) and detach suction line from power steering pump.
Disconnect plug connection on rear side of power steering pump.
Installation note:
Make sure hydraulic lines are laid without tension and with sufficient distance to adjoining components.
Align intake pipe by way of marking "P" (2) to power steering pump connection marking.
Replace hose clamp.
Image of vane pump with ARS!
Release bolts (1) on power steering pump at front.
Tightening torque: 32 41 9AZ .
Turn power steering pump to one side and release screw (1) for pressure line.
Disconnect pressure line (2).
Lift out power steering pump.
Installation note:
Replace sealing ring.
Tightening torque: 32 41 6AZ .
After installation:
- Fill and bleed HYDRAULIC SYSTEM .
- Check pipe connections for leaks.