72 11 070 Removing and installing/replacing front lower belt fitting (belt tensioner), driver's seat
WARNING: This page does not describe the selected car, but rather 21 other vehicles, including the 2017 BMW 550i GT xDrive, 2017 BMW 535i GT xDrive, 2017 BMW 535i GT, 2016 BMW 550i GT xDrive, and 2016 BMW 535i GT xDrive. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Remove FRONT SEAT, DRIVER'S SIDE
Installation:
- Microencapsulated screws (Loctite) must be replaced and may not be reused
- Screw connection must be completed within 20 minutes (start of curing)
- Microencapsulated screws must not be retightened
- Clean thread of nut beforehand in event of repeated use
UNLOCK AND DISCONNECT plug connections (1).
Release screw (1).
Installation:
Replace screw (1).
Tightening torque 72 11 03AZ .
Remove seat belt tensioner.
Installation:
Belt tensioner is coded against incorrect installation.