65 83 020 Removing and installing (replacing) Car Information Computer (CIC)
WARNING: This page does not describe the selected car, but rather 21 other vehicles, including the 2017 BMW 550i GT xDrive, 2017 BMW 535i GT xDrive, 2017 BMW 535i GT, 2016 BMW 550i GT xDrive, and 2016 BMW 535i GT xDrive. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Risk of damage!
A hard disk is installed in the Car Information Computer (CIC).
Carry out mechanical work on the CIC and adjacent components with care.
Avoid subjecting the CIC to vibration/shocks.
IMPORTANT:
Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION)
.
NOTE:
Comply with notes on HANDLING OPTICAL FIBRES
.
Necessary preliminary tasks:
- Disconnect BATTERY EARTH LEAD (F03: Disconnect both battery earth leads).
- Remove RADIO AND IHKA CONTROLS
NOTE:
Picture for example purposes only!
Unfasten screws (2).
Pull CIC (3) out of guide.
Installation note:
Make sure CIC (3) is correctly seated in guide lugs (1).
Unlock plug connections (2) and (3) and disconnect.
Remove CIC (1).
Only for US models with satellite radio:
When replacing the CIC unit, additional work is required!
- Refer to document REPLACING SATELLITE TUNER .
Replacement:
Carry out VEHICLE PROGRAMMING/ENCODING .
For vehicles with Teleservices optional equipment:
- Update services via menu in the central information display.
Load additionally for following vehicles' service history:
- 1-Series F2x, 3-Series F3x from series introduction
- F01, F02, F03, F07, F10, F11 with production date from 07/2013
- F06, F12, F13 with production date from 03/2014
- F15, F16 from volume production launch
- F18 with production date from 09/2013
- F25 with production date from 04/2014
- F26 as of series introduction
Load service history
- 05 Maintenance and Pre-Delivery Check
- Service history