66 53 010 Calibrating reversing camera
WARNING: This page does not describe the selected car, but rather 21 other vehicles, including the 2017 BMW 550i GT xDrive, 2017 BMW 535i GT xDrive, 2017 BMW 535i GT, 2016 BMW 550i GT xDrive, and 2016 BMW 535i GT xDrive. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Calibration of reversing camera must be carried out after the following work:
- Removal and installation/replacement of reversing camera
- Body repair work at rear end of vehicle
- Adjusting work at tailgate
IMPORTANT:
Follow instructions and specifications in procedure.
To obtain an optimum result, always adhere to the following conditions:
To obtain an optimum result, always adhere to the following conditions:
- Vehicle standing level on headlight aiming station
- Rear seat bench is unoccupied
- Do not swap seats during calibration
- Steering wheel in straight-ahead position
- Do not move steering wheel
NOTE:
Also switch on reversing camera by means of PDC button.
Calibration can only be carried out with the BMW diagnosis system.
Use of a special tool is no longer required from 03/2011!
Service functions:
- 04 Driver assistance
- All-round vision camera
- Calibration and teaching in for all-round vision camera