66 20 536 Removing and installing/replacing a rear middle left ultrasonic transducer
WARNING: This page does not describe the selected car, but rather 21 other vehicles, including the 2017 BMW 550i GT xDrive, 2017 BMW 535i GT xDrive, 2017 BMW 535i GT, 2016 BMW 550i GT xDrive, and 2016 BMW 535i GT xDrive. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Risk of burning!
Work on the exhaust system may only be carried out when it has cooled down!
Work on the exhaust system may only be carried out when it has cooled down!
NOTE:
Ultrasonic transducers (3) can be reached from below with bumper installed.
Unlock plug connection (1) and disconnect.
Unlock latch mechanisms (2) and pull ultrasonic transducer (3) out of bracket.
Unlock plug connection (1) and disconnect.
Unlock latch mechanisms (2) and pull ultrasonic transducer (3) out of bracket.
Installation note
Before installation of ultrasonic sensor (3) on wiring harness, clean plug connection!
Retaining tabs (2) must not be damaged!
Make sure ultrasonic sensor is securely seated.
Installation note:
Make sure rubber ring (1) is correctly seated on ultrasonic sensor (2).