66 54 001 Axially adjusting night vision camera

WARNING: This page does not describe the selected car, but rather 21 other vehicles, including the 2017 BMW 550i GT xDrive, 2017 BMW 535i GT xDrive, 2017 BMW 535i GT, 2016 BMW 550i GT xDrive, and 2016 BMW 535i GT xDrive. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Mechanical setting - as described in the following - is only possible axially .
Vertical alignment can only be carried out with the BMW diagnosis system:

Service functions
->Body

-> Night vision electronics

-> Calibration night vision electronics camera

NOTE: Installation location: Adjusting screw, Night Vision Camera F01, 02, 03:
Fold lid (1) in engine compartment lid gasket fixture mounting upwards as pictured.

NOTE: (2) = Installation location, adjusting screw, night vision camera

Fig 1: Identifying Engine Compartment Lid And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Installation location: Adjusting screw, Night Vision Camera F07, F10, 11, 18, F12, 13:
Fold up engine compartment lid seal (1) as shown.

NOTE: (2) = Installation location, adjusting screw, night vision camera

Fig 2: Identifying Engine Compartment Lid Seal And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Fig 3: Adjusting Headlight Aiming Device

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Front of vehicle must be parallel at distance (A) to headlight aiming device (1).
(A) = 2 m
Align a suitable straight object (2), e.g. a spirit level, horizontally on headlight aiming device.
Slowly carry out axial adjustment of night vision camera at adjusting screw (3).

NOTE: Image shows the CID picture in the vehicle.
If necessary, align the image of the night vision camera with aid of a second person.
Yellow help line (1) is displayed using diagnosis job.
Upper edge (2) must be aligned using adjusting screw parallel to yellow help line (1) in the CID.

Fig 4: Aligning Image Of Night Vision Camera

Courtesy of BMW OF NORTH AMERICA, INC.