27 10 070 Replacing output flange on transfer box at rear (ATC350)

WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2017 BMW 550i GT xDrive, 2017 BMW 535i GT xDrive, 2016 BMW 550i GT xDrive, 2016 BMW 535i GT xDrive, and 2015 BMW 550i GT xDrive. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: After completing work, check TRANSMISSION OIL LEVEL and top up if necessary.
Use only the approved transmission oil. Refer to 1.0 TRANSFER CASE OPERATING FLUIDS .

NOTE:

Replace output flange only together with a new radial shaft seal.
Procedure for removing output flange is identical to replacing RADIAL SHAFT SEAL .

Installation note:

Thickness of new shim must be determined before output flange is installed.

Determine and note down dimension A of output flange (old and new).

Fig 1: Identifying Dimension A Of Output Flange (Old And New)

Courtesy of BMW OF NORTH AMERICA, INC.

Determine and note down dimension B of output flange (old and new).

Fig 2: Identifying Dimension B Of Output Flange (Old And New)

Courtesy of BMW OF NORTH AMERICA, INC.

Determine old dimension C, thickness of shim.

Fig 3: Identifying Thickness Of Shim

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Calculate thickness of new shim:

Add old dimension A of output flange (previous) and old dimension C of shim
Then subtract old dimension B from old result A+C
Subtract dimension B from dimension A of output flange (new)
Then subtract result of step 2 from result of step 1.