27 10 050 Replacing output flange for output to the front axle (ATC 350)
WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2017 BMW 550i GT xDrive, 2017 BMW 535i GT xDrive, 2016 BMW 550i GT xDrive, 2016 BMW 535i GT xDrive, and 2015 BMW 550i GT xDrive. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Do not move vehicle with driving power once propeller shaft has been removed.
Replace output flange only together with a new radial shaft seal.
After completion of work, check GEARBOX OIL LEVEL .
Use only the approved gearbox oil. Refer to 1.0 TRANSFER CASE OPERATING FLUIDS .
Failure to comply with this requirement will result in serious damage to the transfer box!
Replace output flange only together with a new radial shaft seal.
After completion of work, check GEARBOX OIL LEVEL .
Use only the approved gearbox oil. Refer to 1.0 TRANSFER CASE OPERATING FLUIDS .
Failure to comply with this requirement will result in serious damage to the transfer box!
Operation is identical to REPLACING RADIAL SHAFT SEAL FOR OUTPUT TO THE FRONT AXLE .