26 11 090 Removing and installing/replacing front centering mount for propeller shaft

WARNING: This page does not describe the selected car, but rather 21 other vehicles, including the 2017 BMW 550i GT xDrive, 2017 BMW 535i GT xDrive, 2017 BMW 535i GT, 2016 BMW 550i GT xDrive, and 2016 BMW 535i GT xDrive. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

00 5 500
11 1 310
11 2 030

Necessary preliminary tasks:

Remove PROPELLER SHAFT .

Completely fill centering bore hole (1) with viscous grease.

Drive special tool 11 1 310 with a plastic hammer into centering bore hole.

The centering bearing (1) is forced out of the propeller shaft by the pressure on the grease filling.

If necessary, top up grease repeatedly.

Fig 1: Driving Special Tool 11 1 310 Using Plastic Hammer Into Centering Bore Hole

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: To drive out the bearing, you can also fill the centering bore hole with water instead of grease.

Installation note:

Remove grease or water from mount bore.

Drive in centering mount (1) with special tools 11 2 030 and 00 5 500 into propeller shaft (observe protrusion).

Grease centering mount.

Grease: refer to OPERATING FLUIDS .

Fig 2: Driving Centering Mount Into Propeller Shaft Using Special Tools 11 2 030 And 00 5 500
Courtesy of BMW OF NORTH AMERICA, INC.

Installation note

Observe protrusion A = 4⁺² mm of centering (1).

Fig 3: Identifying Protrusion Of Centering

Courtesy of BMW OF NORTH AMERICA, INC.