12 41 020 Remove and install/replace the starter motor (N63 B40/B44 O 1)

WARNING: This page does not describe the selected car, but rather 21 other vehicles, including the 2017 BMW 550i GT xDrive, 2017 BMW 535i GT xDrive, 2017 BMW 535i GT, 2016 BMW 550i GT xDrive, and 2016 BMW 535i GT xDrive. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks

Switch off ignition.
Disconnect BATTERY NEGATIVE LEAD .
Remove right ENGINE SUPPORT ARM .

Release screws (1).

Tightening torque 12 41 1AZ .

Fig 1: Identifying Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock connector (1) and remove.

Slacken nut (2).

Tightening torque 12 42 2AZ .

Disconnect positive battery cable.

Release screws (3) and detach cable clip from starter motor.

Remove starter motor (4) in direction of travel.

Fig 2: Removing Starter Motor

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Check starter pinion and starter ring gear for damage. If necessary, replace damaged components.

Reassemble the vehicle.

Only during starter replacement and on vehicles with MSA (automatic engine start-stop function)

Use BMW diagnosis system to reset the starter counter.