12 14 513 Replacing pulse sensor on right exhaust camshaft (N63 B40/B44 O 1)

WARNING: This page does not describe the selected car, but rather 21 other vehicles, including the 2017 BMW 550i GT xDrive, 2017 BMW 535i GT xDrive, 2017 BMW 535i GT, 2016 BMW 550i GT xDrive, and 2016 BMW 535i GT xDrive. However, it is still accessible from the selected car via links, so may be relevant.

(cylinder bank 1 to 4)

Necessary preliminary tasks

Read out fault memory of the DME control unit, work through test plans if necessary.
Switch off ignition.
Remove right-hand INTAKE SILENCER HOUSING

Partially release wiring harness if necessary.

Unlock connector (1) and remove.

Release screw (2).

Tightening torque 13 62 3AZ .

Remove pulse generator (3).

Installation note:

Replace sealing ring and coat with lubricant.

Fig 1: Identifying Connector, Screw And Pulse Generator

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Delete fault memory.