13 54 020 Removing and installing/sealing right throttle valve assembly (N63)

WARNING: This page does not describe the selected car, but rather 21 other vehicles, including the 2017 BMW 550i GT xDrive, 2017 BMW 535i GT xDrive, 2017 BMW 535i GT, 2016 BMW 550i GT xDrive, and 2016 BMW 535i GT xDrive. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks

Turn off ignition
Remove right INTERCOOLER

NOTE: Picture shows the left throttle valve assembly, the procedure for the right side is identical.

Unlock plug (1) and remove.

Unfasten screws (2).

Tightening torque 13 54 1AZ .

Remove throttle valve assembly (3).

Installation :

Check plug connection (1) for coolant remnants. If necessary, clean plug connection (1) with compressed air.

Fig 1: Identifying Throttle Valve Assembly, Plug Connection And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation

Replace sealing ring (1) of throttle assembly (2).

Fig 2: Identifying Sealing Ring Of Throttle Assembly

Courtesy of BMW OF NORTH AMERICA, INC.

Installation :

Check stored fault message.

clear fault memory.