13 54 020 Removing and installing/sealing right throttle body (N63 B44/B40 O 1)

WARNING: This page does not describe the selected car, but rather 21 other vehicles, including the 2017 BMW 550i GT xDrive, 2017 BMW 535i GT xDrive, 2017 BMW 535i GT, 2016 BMW 550i GT xDrive, and 2016 BMW 535i GT xDrive. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks

Switch off ignition.
Remove right INTERCOOLER .

NOTE: Picture shows the left throttle body, the procedure for the right side is identical.

Unlock connector (1) and remove.

Unfasten screws (2).

Tightening torque 13 54 1AZ .

Remove throttle body (3).

Installation note:

Check the plug connection (1) for coolant residue. If necessary, blow clean plug connection (1) with compressed air.

Fig 1: Identifying Throttle Valve Assembly, Plug Connection And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Replace sealing ring (1) of throttle body (2).

Fig 2: Identifying Sealing Ring Of Throttle Assembly

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Check stored fault message.

Delete fault memory.