41 14 021 Replacing Front Left Wheel Arch Stripping Operations

WARNING: This page is about a different car, the 2013 BMW 550i GT, 2012 BMW 550i GT, 2011 BMW 550i GT, and 2010 BMW 550i GT. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Owing to the different engine variants and equipment specifications, not all the components are taken into consideration.
The following list basically represents the removal sequence.

Disconnect negative battery cable (FR number: 61 20 900)
Remove bumper trim (job number: 51 11 156
Remove bumper support (job number: 51 11 050)
Remove headlight (job number: 63 12 010)
Remove radiator (job number: 17 11 000)
Remove A/C system condenser (job number: 64 53 550)
Remove and install charge air cooler (job number: 17 51 000)
Remove hydraulic steering cooling coil (job number: 17 11 370)
Remove intake silencer housing (job number: 41 35 111)
Remove coolant expansion tank (job number: 17 11 100)
Remove wheel arch cover (front section) (job number: 51 71 038)
Remove wheel arch cover (rear section) (job number: 51 71 039)
Front axle complete with engine and transmission (job number: 31 10 001)
Engine compartment lid seal locator (job number 51 76 035).
Remove engine compartment lid (job number 41 61 000)
Remove engine compartment lid hinge (job number: 41 61 050)
Remove left side wall (job number: 41 35 050)
Remove top left wishbone (job number: 31 12 002)
Remove left suspension brace (job number: 51 71 345)
Remove bulkhead sound insulation
Remove brake booster (job number: 34 33 000)
Remove/detach hydraulic lines for power steering pump.
Detach coolant hoses
Detach fuel lines
Release left wiring harness
Partially release/remove thermal protection