65 77 532 Removing and installing/replacing front left sensor (US version only)

WARNING: This page is about a different car, the 2013 BMW 550i GT, 2012 BMW 550i GT, 2011 BMW 550i GT, and 2010 BMW 550i GT. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks

Remove FRONT LEFT WHEEL ARCH COVER .

NOTE: This work step varies according to engine type.

Release screw (1) on auxiliary radiator bracket (2).

Remove holder (2) and carefully place to one side.

Fig 1: Identifying Screw, Holder And Bracket

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Holder (2) must be correctly seated in the designated guides.

Release screws (1) on lock carrier (2).

Tightening torque 65 77 2AZ .

Feed out sensor (3).

Unfasten plug connection (2) and disconnect.

Installation:

Make sure sensor (3) is in correct installation position.

Sensor surface must point upwards.

Plug connection (2) must point in opposite direction to direction of travel.

Fig 2: Identifying Screws, Lock Carrier, Plug Connection And Sensor

Courtesy of BMW OF NORTH AMERICA, INC.