72 11 071 Removing and installing/replacing front lower strap fitting (belt tensioner), front passenger seat
WARNING: This page is about a different car, the 2013 BMW 550i GT, 2012 BMW 550i GT, 2011 BMW 550i GT, and 2010 BMW 550i GT. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary work
- Remove FRONT PASSENGER SEAT .
Installation note:
- Microencapsulated screws (Loctite) must be replaced and may not be reused.
- Screw connection must be completed within 20 minutes (start of hardening).
- Microencapsulated screws must not be retightened.
- Clean thread of nut beforehand in event of repeated use.
UNLOCK AND DISCONNECT plug connections (1).
Release screw (1).
Installation note:
Replace screw (1).
Tightening torque, see 72 11 03AZ.
Remove seat belt tensioner.
Installation note:
Belt tensioner is coded against incorrect assembly.