66 54 015 Replacing lens cover for night vision camera

WARNING: This page is about a different car, the 2013 BMW 550i GT, 2012 BMW 550i GT, 2011 BMW 550i GT, and 2010 BMW 550i GT. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION) .

Necessary preliminary tasks

Completely remove NIGHT VISION CAMERA .

Unlock latch mechanisms (1) and unfasten cover (2) in direction of arrow.

Fig 1: Turning Lens Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Carefully remove sealing ring (1).

IMPORTANT: Adjoining surface of lens must not be damaged when sealing ring is removed!

Installation note:

Replace sealing ring.

Fig 2: Removing Sealing Ring

Courtesy of BMW OF NORTH AMERICA, INC.

Thoroughly clean seal recess (1) with cleaning agent containing alcohol and cotton bud.

Fig 3: Identifying Seal Recess

Courtesy of BMW OF NORTH AMERICA, INC.

After installation

Adjust NIGHT VISION CAMERA .
Fill up with washer fluid.