37 12 310 Removing and installing/replacing rear left or right shock absorber

WARNING: This page is about a different car, the 2013 BMW 550i GT, 2012 BMW 550i GT, 2011 BMW 550i GT, and 2010 BMW 550i GT. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Read and comply with NOTES ON REPLACING SHOCK ABSORBERS .
Read and comply with BMW Parts Department notes.

IMPORTANT: Handle the spring strut with care so as to avoid damaging the control unit (1) and control valve (2).

Fig 1: Identifying Spring Strut Control Unit And Control Valve

Courtesy of BMW OF NORTH AMERICA, INC.

Necessary preliminary work

Remove REAR WHEEL .
Deactivate and drain AIR SPRING SYSTEM .

If applicable, disconnect the plug connections (1) and expose lines up to shock absorber.

Fig 2: Identifying Shock Absorber Plug Connections

Courtesy of BMW OF NORTH AMERICA, INC.

Remove cover (1).

Fig 3: Identifying Shock Absorber Plug Connections Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1).

Installation note:

Before tightening screw/bolt connection, check that shock absorber pin is correctly positioned in swinging arm. Screw must not be used as a fitting aid to installing the shock absorber!

Replace bolt!

Tighten bolt in NORMAL POSITION .

Tightening torque, 33 52 4AZ .

Fig 4: Identifying Shock Absorber Bolt

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws at support bearing.

Replace self-locking screws!

Tightening torque, 33 52 1AZ .

Fig 5: Locating Support Bearing Self-Locking Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Check O-ring and replace if necessary.

Fig 6: Identifying Support Bearing O-Ring

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement

Modify SUPPORT BEARING .

Modify auxiliary absorber (1) and protective tube (2) incl. support cup.

Installation note:

Check auxiliary absorber (1) and protective tube (2) for damage, replace if necessary.

Fig 7: Identifying Auxiliary Absorber And Protective Tube

Courtesy of BMW OF NORTH AMERICA, INC.

After Installation note

Activate and fill AIR SPRING SYSTEM .
Replacement only: Program/encode the shock absorber and check the software version.
If applicable, perform the VERTICAL ACCELERATION SENSOR ADJUSTMENT in the event of a replacement only.