37 12 012 Carrying out ride height adjustment

WARNING: This page is about a different car, the 2013 BMW 550i GT, 2012 BMW 550i GT, 2011 BMW 550i GT, and 2010 BMW 550i GT. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Ride height adjustment must be carried out after the following work:

Removal/replacement of ride height sensor or its control rod (only necessary for vehicles with air suspension or vehicles with VDC)
Replacement of wiring harness
Replacement of air supply system control unit (F01/F02/F04/F07/F11)
Replacement of vertical dynamics management control unit
Replacement of ICM control unit (Integrated Chassis Management)

Connect BMW diagnosis system.

Switch the ignition on.

Carry out ride height adjustment (menu item: "Service function").

IMPORTANT: Following ride height adjustment, for vehicles with:

Run Flat Indicator: initialize RUN FLAT INDICATOR .
Tyre Pressure Monitor: RESETTING TYRE PRESSURE MONITOR .