37 14 515 Replacing front left or right ride-height sensor

WARNING: This page is about a different car, the 2013 BMW 550i GT, 2012 BMW 550i GT, 2011 BMW 550i GT, and 2010 BMW 550i GT. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Observe SAFETY INSTRUCTIONS for raising the vehicle.

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION) .

Unfasten plug connection (1) and disconnect.

Release nut (2) and disconnect jointed rod.

Tightening torque 37 14 4AZ .

Release screw (3) and remove ride-height sensor (4).

Tightening torque 37 14 2AZ .

Fig 1: Identifying Front Left/Right Ride-Height Sensor Plug Connections With Mounting Nuts And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Release screws (1). Remove bracket (2) from ride-height sensor.

Tightening torque 37 14 3AZ .

Fig 2: Identifying Front Left/Right Ride-Height Sensor Plug Connections With Brackets And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

After installation

Carry out RIDE-HEIGHT CALIBRATION .
Check HEADLIGHT ADJUSTMENT , correct if necessary.