52 25 412 Replacing backrest cover for right rear seat

Special tools required: 

• 52 0 050

Necessary preliminary tasks 

• Remove right REAR SEAT .
• Remove HEAD RESTRAINT .

With seat heating only as optional equipment: 

Unfasten plug connection (1) and disconnect.

Fig 1: Identifying Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1) from rubber retainer.

Tightening torque 52 25 03AZ .

Fig 2: Identifying Rubber Retainer Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Remove backrest cover with padding towards top.

Fig 3: Removing Backrest Cover With Padding

Courtesy of BMW OF NORTH AMERICA, INC.

Detaching cover and upholstery: 

• Release all clamps in marked area
• Remove cover from upholstery
• Remove remaining clamps from cover and upholstery

Replacement only: 

• Pull all trim wires out of cover
• If necessary, cut pockets in new cover for trim wires
• Push trim wires into cover pockets
  Fig 4: Identifying Clamps Area On Cover And Upholstery

  Courtesy of BMW OF NORTH AMERICA, INC.

Installation note: 

Insert new clamp (2) with special tool 52 0 050 and bend closed.

1. Upholstery
2. Clamp
3. Trim wire in upholstery
4. Trim wire in seat cover
5. Backrest cover
   Fig 5: Inserting Clamp Using Special Tool (52 0 050)

   Courtesy of BMW OF NORTH AMERICA, INC.