54 13 090 Removing and installing/replacing wind deflector

Necessary preliminary work 

• Open slide/tilt sunroof

Insert screwdriver (1) between the two holders.

Fig 1: Inserting Screwdriver Between Two Holders

Courtesy of BMW OF NORTH AMERICA, INC.

Press wind deflector (1) down.

Keep screwdriver (2) in position.

Fig 2: Pressing Wind Deflector Using Screwdriver

Courtesy of BMW OF NORTH AMERICA, INC.

Continue pressing down on wind deflector (1).

Insert screwdriver (2) next to first hold-down device (3).

Fig 3: Pressing Down Wind Deflector Using Screwdriver

Courtesy of BMW OF NORTH AMERICA, INC.

Push welt (1) of net away from hold-down device using screwdriver (2).

Fig 4: Pushing Net Welt From Hold-Down Device Using Screwdriver

Courtesy of BMW OF NORTH AMERICA, INC.

Lift welt (1) out over holders using screwdriver.

Repeat procedure on remaining holders and hold-down devices.

Installation note: 

First slide welt of net below outer hold-down device.

Press welt over holders until welt engages audibly.

Fig 5: Lifting Welt From Holders Using Screwdriver

Courtesy of BMW OF NORTH AMERICA, INC.

Press retaining lugs on left and right and push slide (1) forward.

Remove wind deflector.

Fig 6: Pressing Left And Right Retaining Lugs

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note: 

Make sure spring (1) is fitted correctly.

Fig 7: Identifying Wind Deflector Spring

Courtesy of BMW OF NORTH AMERICA, INC.