51 13 280 Removing and installing/replacing trim strip on roof frame at left or right

WARNING: This page is about a different car, the 2013 BMW 550i GT, 2012 BMW 550i GT, 2011 BMW 550i GT, and 2010 BMW 550i GT. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

00 9 321

Graphics are similar.

Lever out trim strip (1) with special tool 00 9 321 starting at the front.

Unclip trim strip (1) in direction of arrow.

Fig 1: Removing Trim Strip Using Special Tool (00 9 321)

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Catches (1) of clips (2) must not be damaged.

If necessary, replace clips (2).

Emergency strategy if T-bolt is broken:

REPAIRING CLIPS FOR ROOF STRIP

Fig 2: Identifying Catches And Clips

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Place front trim strip (2) against seal (1).

Trim strip (2) must be flush with edge (3) at rear.

Clip trim strip (2) into place completely.

Fig 3: Installing Trim Strip

Courtesy of BMW OF NORTH AMERICA, INC.