If necessary, incoming check

WARNING: This page is about a different car, the 2013 BMW 550i GT, 2012 BMW 550i GT, 2011 BMW 550i GT, and 2010 BMW 550i GT. However, it is still accessible from the selected car via links, so may be relevant.

Prior to any adjustments, perform the following incoming checks:

NOTE: Incoming check is performed while weather strip is installed.

Delete the initialization of the POWER WINDOW REGULATOR .
Measure retraction depths with special tool 51 3 080.
Insert the special tool 51 0 370 (green) into the rotary striker and close the rotary striker.
51 0 342 Measure preload with special tool.
Initialize the POWER WINDOW REGULATORS .

NOTE: Perform the adjusting procedures with denormalised POWER WINDOW REGULATORS .