51 49... Removing and installing/replacing rear lid storage shelf

WARNING: This page is about a different car, the 2013 BMW 550i GT, 2012 BMW 550i GT, 2011 BMW 550i GT, and 2010 BMW 550i GT. However, it is still accessible from the selected car via links, so may be relevant.

Release screws (1), turn retainers (2) on trim panel (3) 90° to release, remove cover (4) in direction of arrow

Tightening torque: 51 49 3AZ

Fig 1: Removing Rear Lid Storage Shelf Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Release retaining rail (2) screw (1) and unclip journal (4) from retainer (3) in direction of arrow.

Tightening torque: 51 49 4AZ

Retainer (3) and journal (4) must not be damaged, replace if necessary.

Fig 2: Removing Retaining Rail Screw And Journal From Retainer

Courtesy of BMW OF NORTH AMERICA, INC.