51 16 150 Removing and installing/replacing front storage compartment

WARNING: This page is about a different car, the 2013 BMW 550i GT, 2012 BMW 550i GT, 2011 BMW 550i GT, and 2010 BMW 550i GT. However, it is still accessible from the selected car via links, so may be relevant.

When working on trim panel components, make sure that the sensitive surfaces are not scratched or damaged.

Open storage compartment (1).

Ideally, first unlatch left and right cover (2) by pulling it down then up on the marked locations. Then fold to the inside and remove.

Installation:

Retaining lugs of cover (2) of door trim panel must not be damaged.

Fig 1: Identifying Storage Compartment And Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Release left and right screws (1).

Pull out storage compartment (2) and put aside.

Fig 2: Identifying Storage Compartment And Screws

Courtesy of BMW OF NORTH AMERICA, INC.