51 14 111 Replacing model name plate, rear: Notes
WARNING: This page is about a different car, the 2013 BMW 550i GT, 2012 BMW 550i GT, 2011 BMW 550i GT, and 2010 BMW 550i GT. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
This describes a general
procedure for replacement and new bonding of model designations/lettering using the 335i (F30) as an example.
The procedure can be used for all models, positions and installation locations.
The model designation is attached with adhesive and can not be reused.
The procedure can be used for all models, positions and installation locations.
The model designation is attached with adhesive and can not be reused.
Refer to INSTRUCTIONS for securing components with adhesive tape!
| Cutting cord |
| Masking tape 19 mm or 30 mm |
| Yellow plastic adhesive tape |
| Eraser disk |
| Cleaning agent R2 |