12 14 521 Replacing crankshaft pulse generator (N63)
WARNING: This page is about a different car, the 2013 BMW 550i GT, 2012 BMW 550i GT, 2011 BMW 550i GT, and 2010 BMW 550i GT. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary work
- Read out the fault memory of the DME control unit.
- Switch off ignition.
- Remove rear UNDERBODY PROTECTION.
Installation location
On transmission housing at bottom right.
Release connector (1) and remove.
Release screw (2).
Withdraw pulse generator (3) from transmission housing.
Installation note:
Delete fault memory.