61 31 336 Removing and installing/replacing cover for gear selector switch

WARNING: This page is about a different car, the 2013 BMW 550i GT, 2012 BMW 550i GT, 2011 BMW 550i GT, and 2010 BMW 550i GT. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks

Disconnect NEGATIVE BATTERY CABLE .
Remove both negative battery cables at F03.
Remove CENTRE CONSOLE COVER .

NOTE: Trim for gear selector switch (2) is secured from version 04/2009 with four screws.

Release screws (1) and raise trim for gear selector switch (2) slightly.

Unlock and disconnect plug connection underneath for EMF switch.

Twist cover for gear selector switch (2) 90° and feed out upwards from the gear selector switch.

Fig 1: Identifying Gear Selector Switch With Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Remove SWITCH FOR ELECTROMECHANICAL PARKING BRAKE .