61 31 233 Removing and installing/renewing Lane Departure Warning engine electrical system (TLC actuator)
WARNING: This page is about a different car, the 2013 BMW 550i GT, 2012 BMW 550i GT, 2011 BMW 550i GT, and 2010 BMW 550i GT. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks
- Remove airbag unit . See 32 34 030 REMOVING AND INSTALLING/REPLACING AIRBAG UNIT (SPORT STEERING WHEEL) or 32 34 020 REMOVING AND INSTALLING/REPLACING AIRBAG UNIT .
Remove lower steering wheel trim
Disconnect plug connection (1).
Release screws (2) and remove engine electrics (3).
Tightening torque 32 33 2AZ .
Installation note:
Replace screws (2).
Ensure correct cable routing.
Replacement from build date 03/2009:
Engine electrical system must be readjusted.
The service module "Adjustment actuator Lane Departure Warning" can be found at:
- Body
- Camera-based driver support systems
- Adjustment actuator Lane Departure Warning