61 31 221 Removing and installing/replacing both multifunction steering wheel switches

WARNING: This page is about a different car, the 2013 BMW 550i GT, 2012 BMW 550i GT, 2011 BMW 550i GT, and 2010 BMW 550i GT. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks

Remove airbag unit . See 32 34 030 REMOVING AND INSTALLING/REPLACING AIRBAG UNIT (SPORT STEERING WHEEL) or 32 34 020 REMOVING AND INSTALLING/REPLACING AIRBAG UNIT .
Release both shift paddles if necessary

Release screws (1) on left/right on back of steering wheel (2).

Fig 1: Identifying Steering Wheel Back With Screw

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Both multifunction steering wheel switches (1) are connected to each other by the wiring harness (2).

Feed wiring harness (2) out of steering wheel.

Remove both multifunction steering wheel switches (1) in direction of arrow.

Fig 2: Removing Multifunction Steering Wheel Switches

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1) and remove both multifunction steering wheel switches (2).

Installation note:

Make sure electrical wiring is correctly routed.

Fig 3: Identifying Multifunction Steering Wheel Switch With Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.