61 67 100 Removing and installing/replacing left high-pressure nozzle of headlight cleaning system

WARNING: This page is about a different car, the 2013 BMW 550i GT, 2012 BMW 550i GT, 2011 BMW 550i GT, and 2010 BMW 550i GT. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

13 3 010

Necessary preliminary tasks

REMOVE FRONT BUMPER PANEL .

To prevent excess escape of washer fluid, seal off end of high pressure line with special tool. 13 3 010

Fig 1: Sealing High Pressure Line End Using Special Tool (13 3 010)

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock high pressure line (1) and detach from high-pressure nozzle (2).

Fig 2: Identifying High Pressure Line With Nozzle

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock high-pressure nozzle (1) and remove in direction of arrow rearwards.

Fig 3: Removing High-Pressure Nozzle

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Ensure guide (1) is correctly seated.

New washer jets are already preset.

Top up washer fluid.

Carry out function check.

Fig 4: Identifying Washer Jets Guide

Courtesy of BMW OF NORTH AMERICA, INC.