61 12 062 Replacing wiring harness for front bumper
WARNING: This page is about a different car, the 2013 BMW 550i GT, 2012 BMW 550i GT, 2011 BMW 550i GT, and 2010 BMW 550i GT. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Read and comply with notes on HANDLING WIRING HARNESSES
and cables.
Necessary preliminary tasks
- Remove FRONT BUMPER TRIM .
Disconnect plug connections (1) on five ultrasonic transducers.
Unclip wiring harness (2) from bumper trim.
Remove wiring harness (2).
Remove PDC . See 66 20 515 REMOVING AND INSTALLING/REPLACING A FRONT LEFT ULTRASONIC TRANSDUCER (PDC) , 66 20 516 REMOVING AND INSTALLING/REPLACING A FRONT RIGHT ULTRASONIC SENSOR (PDC) , 66 20 517 REMOVING AND INSTALLING/REPLACING A FRONT CENTRE LEFT ULTRASONIC SENSOR (PDC) or 66 20 519 REMOVING AND INSTALLING/REPLACING A FRONT, CENTRE RIGHT ULTRASONIC TRANSDUCER (PDC) .
Installation:
Make sure wiring harness (2) is laid correctly.