00 00... Tires: checking and if necessary correcting inflation pressure, checking condition, tread depth and pattern

WARNING: This page is about a different car, the 2013 BMW 550i GT, 2012 BMW 550i GT, 2011 BMW 550i GT, and 2010 BMW 550i GT. However, it is still accessible from the selected car via links, so may be relevant.

Checking tire pressure:
- Check tire pressure in accordance with label on B-pillar.
Check tire condition:
- Check tread depth of all tires with tire tread gauge
- Check tire tread surfaces and side walls for incisions and foreign particles such as nails or screws
- Check tread wear pattern for localized flattening and wear on one side; if necessary, carry out wheel/chassis alignment after consulting with customer and issue a separate invoice for this work

NOTE:

For reasons of driving safety, only use tires of the same design and tire tread on a single vehicle.
Inform customer of any incorrect or worn tires