00 00 006 Vehicle test
WARNING: This page is about a different car, the 2013 BMW 550i GT, 2012 BMW 550i GT, 2011 BMW 550i GT, and 2010 BMW 550i GT. However, it is still accessible from the selected car via links, so may be relevant.
Connect diagnosis system.
Switch the ignition on.
Carry out vehicle identification.
Click on brief test.
The vehicle test is carried out.
NOTE:
For motor vehicle diagnosis, the brief test is essential for evaluating possible stored fault codes. In the vehicle test, the control units are physically identified in succession and their fault memories read out.
If the fault memory has been read out, the faults appear in the "Fault pattern selection" mask in the "Fault memory contents" field.
Check identified faults and if necessary rectify these faults after consulting with customer.
If the fault memory has been read out, the faults appear in the "Fault pattern selection" mask in the "Fault memory contents" field.
Check identified faults and if necessary rectify these faults after consulting with customer.