LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2014 >> M6 2D Convertible, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 337 (Body Equipment - Tightening Torques) >> Rear Bumper >> 51 12 Rear bumper

51 12 Rear bumper

WARNING: This page is about a different car, the 2013 BMW 550i GT, 2012 BMW 550i GT, 2011 BMW 550i GT, and 2010 BMW 550i GT. However, it is still accessible from the selected car via links, so may be relevant.
TIGHTENING TORQUE SPECIFICATIONS - REAR BUMPER

  Type Thread Tightening specifications Dimension
1AZ Support to body F01 / F02 / F03 / F04 / F06 / F12 / F13 M12 Replace nuts 66 Nm
F07 / F10 / F11 / F18 M12   108 Nm
F25     68 Nm
2AZ Guide, middle rear F01 / F02 / F03 / F04 / F06 / F07 / F10 / F11 / F12 / F13 / F18   Replace nuts 4 Nm
F25   Replace nuts 4.5 Nm
3AZ Guide, side, to body F01 / F02 / F03 / F04 / F06 / F07 / F10 / F11 / F12 / F13 / F18, F25   Replace nuts 4.5 Nm
Screw 3 Nm
4AZ Trailer tow hitch to bumper support        
5AZ Bumper trim panel to side fixture F07 / F10 / F11 / F18     2 Nm
F25     2.5 Nm
6AZ Bumper trim panel to rear light housing F07 / F25     4.5 Nm
F06 / F10 / F11 / F12 / F13 / F18     2 Nm
7AZ Bumper trim panel to lower centre fixture F07 / F10 / F11 / F18     4.5 Nm
8AZ Rear silencer holder F07 / F10 / F11 / F12 / F13 / F18 Nut   21 Nm
9AZ Cover on body F25 Nut   5 Nm
10AZ Bottom guide to luggage compartment floor F10 M5     4 Nm