34 21 Rear Brake
WARNING: This page is about a different car, the 2013 BMW 550i GT, 2012 BMW 550i GT, 2011 BMW 550i GT, and 2010 BMW 550i GT. However, it is still accessible from the selected car via links, so may be relevant.
TIGHTENING TORQUE SPECIFICATIONS - REAR BRAKE
| Type | Thread | Tightening specifications | Dimension | |
|---|---|---|---|---|
| 1AZ Brake disc to wheel hub | F01, F02, F03, F04, F06, F07, F10, F11, F12, F13, F18, F25 | M8 | Replace screw | 16 Nm |
| 2AZ Brake anchor plate to wheel carrier | F01, F02, F04, F06, F07, F10, F11, F12, F13, F18 | M12x1.5 | 110 Nm | |
| F03 | M14x1.5 | Replace screws. Important: Observe 4 phase tightening! |
||
| Jointing torque | 150 Nm | |||
| Release | min.90 ° | |||
| Jointing torque | 150 Nm | |||
| Angle of rotation | 180°± 15° | |||
| F25 | M12x1.5 | Replace screws. | ||
| Jointing torque | 75 Nm | |||
| Angle of rotation | 45°10° | |||
| 3AZ Protective plate to wheel carrier | F01, F02, F03, F04, F06, F07, F10, F11, F12, F13, F18, F25 | M6 | Replace screws | 12 Nm |
| 4AZ Guide screw (brake caliper to brake anchor plate) | F01, F02, F03, F04, F07 | WAF 7 | 30-5 Nm | |
| 5AZ Guide screw (brake caliper to brake anchor plate) | F06, F10, F11, F12, F13, F18, F25 | WAF 13 | Replace screws | 35 Nm |