34 11 Front Brake
WARNING: This page is about a different car, the 2013 BMW 550i GT, 2012 BMW 550i GT, 2011 BMW 550i GT, and 2010 BMW 550i GT. However, it is still accessible from the selected car via links, so may be relevant.
TIGHTENING TORQUE SPECIFICATIONS - FRONT BRAKE
| Type | Thread | Tightening specifications | Value | |
|---|---|---|---|---|
| 1AZ Brake disc to wheel hub | F01, F02, F03, F04, F06, F07, F10, F11, F12, F13, F18, F25 | M8 | Replace screws. | 16 Nm |
| 2AZ Brake anchor plate to swivel bearing | F01, F02, F04, F06, F07, F10, F11, F12, F13, F18 | M12x1.5 | 110 Nm | |
| F03 | M14x1.5 | Replace screws. Important: Observe 4 phase tightening! |
||
| Jointing torque | 150 Nm | |||
| Release | min.90 ° | |||
| Jointing torque | 150 Nm | |||
| Angle of rotation | 180°±15° | |||
| F25 | M12x1.5 | Replace screws. | ||
| Jointing torque | 75 Nm | |||
| Angle of rotation | 45°10° | |||
| 3AZ Guard plate to swivel bearing | F01, F02, F03, F04, F06, F07, F10, F11, F12, F13, F18, F25 | M6 | Replace screws. | 12 Nm |
| 4AZ Guide bolt (brake caliper to brake anchor plate) | F01, F02, F03, F04, F06, F07, F10, F11, F12, F13, F18, F25 | SW9 | 55 Nm | |
| F07, F06, F10, F11, F12, F13, F18, F25 | SW7 | 30-5 Nm | ||
| 5AZ Brake caliper at swivel bearing | F10 / F12 / F13 / Nur M-Modelle | M12x1.5 | Hexagon nut | 95 Nm |
| 6AZ Stud bolt (for brake caliper) in wheel carrier | F10 / F12 / F13, Nur M-Modelle | Clean the thread in the wheel carrier and renew the stud bolt | 20 Nm |