33 55 021 Replacing both rubber mounts for stabiliser mounting

WARNING: This page is about a different car, the 2013 BMW 550i GT, 2012 BMW 550i GT, 2011 BMW 550i GT, and 2010 BMW 550i GT. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks

Remove STABILISER FROM REAR AXLE CARRIER

IMPORTANT: Circo Light must not be used between stabiliser and rubber mount!

Remove retaining bracket (1) and rubber mount (2) from stabiliser.

Installation:

Coat rubber mount with Circo Light to install retaining bracket.

Fig 1: Identifying Retaining Bracket And Rubber Mount

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Keep stabiliser clean and free of oil and grease.

Mount rubber mount (1) by way of slot (2) as pictured on stabiliser.

Fig 2: Identifying Rubber Mount And Slot

Courtesy of BMW OF NORTH AMERICA, INC.