LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2014 >> M6 2D Convertible, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 331 (Rear Axle - Repair) >> Stabiliser Bar >> 33 11... Removing and installing/replacing vibration absorber >> Vibration absorber to anti-roll bar, right

Vibration absorber to anti-roll bar, right

WARNING: This page is about a different car, the 2013 BMW 550i GT, 2012 BMW 550i GT, 2011 BMW 550i GT, and 2010 BMW 550i GT. However, it is still accessible from the selected car via links, so may be relevant.

Release screws (1).

Tightening torque 33 55 3AZ .

Remove vibration absorber (2).

Installation note: 

Replace screw.

Fig 1: Identifying Anti-Roll Bar Vibration Absorber And Screws
G08484378Courtesy of BMW OF NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals