33 41 Wheel Bearings
WARNING: This page is about a different car, the 2013 BMW 550i GT, 2012 BMW 550i GT, 2011 BMW 550i GT, and 2010 BMW 550i GT. However, it is still accessible from the selected car via links, so may be relevant.
TIGHTENING TORQUE SPECIFICATIONS - WHEEL BEARINGS
| Type | Thread | Tightening specifications | Dimension | |
|---|---|---|---|---|
| 1AZ Output shaft on drive flange hub | F01 / F02 / F04 / F06 / F07 / F10 / F11 / F12 / F13 / F18 / F25 | M27 | Replace collar nut. Jointing torque and angle of rotation must be observed without fail. |
|
| Jointing torque | 100 Nm | |||
| Angle of rotation | 45 ° | |||
| F10 M5 / F12 M6 / F13 M6 | M16 | Observe the repair instructions. Replace collar bolt and spring. |
||
| Jointing torque | 50 Nm | |||
| Angle of rotation | 155 ° | |||
| F03 | M27 | Replace collar nut. | 420 Nm | |
| 2AZ Wheel bearing to wheel carrier | F01 / F02 / F04 / F06 / F07 / F10 / F11 / F12 / F13 / F18 / F25 | M12 | Replace screws. | 100 Nm |